Hi Dimitra, Yes, I have included the extracted view and included it in the 'Switch View List' as you mentioned. As far as i have understood and verified till now is that when you include the extracted view and run the simulation, then it will include the Parasitic information( RC information related to layout) in the netlist itself. That means the netlist that has been generated after including the extracted view has not only the design information but also the Resistor and capacitor information associated with each node. So, for doing post layout simulation, we don't need to write any extra command in our ocean script,as netlist has already information about the parasitic. And When you run the simulation, netlist keep on modifying itself. Please correct me if i am wrong somewhere. As you have mentioned "design( LibName CellName ViewName) ".Yes i have used it too earlier to generate the netlist of design without opening the GUI view of design. I was wondering if there is any ocean command that generate the netlist after including the extracted view, without opening the GUI view?? Regards, Ishant Anand![]()
↧