Quantcast
Channel: Jason Andrews Blog
Viewing all articles
Browse latest Browse all 33813

RE: probing signal in av_extracted_RC

$
0
0
Hi Hans For step "b", I meant doing the simulation using a config view. I should written "extracted view linked to config view". You are trying to probe the voltage/current of the parasitic resistors. This cannot be done by the out-of-context probing which only probes RLCK values. The results browser should actually have the info. E.g. Rj1 (IN \8\:IN) resistor r=0.9789 l=1.305e-06 w=8e-08 tc1=0 tc2=0 c=0 The node voltage for parasitic res Rj1 can be found in the results browser. Is your results browser not showing the info? Best regards Quek Best regards Quek

Viewing all articles
Browse latest Browse all 33813

Trending Articles