Hi Kevin, Two things. First of all, the hierarchy separator in spectre needs to be "." not "/". The forward slash is what is used in Virtuoso, but not in spectre, which needs a dot. So it would be save I0.Mcp:oppoint. Secondly, in ADE you have Outputs->To be saved->Select OP Parameters which allows you to point at the device and specify which operating point parameters to save rather than having to use an include file. The include file approach is only really needed in older versions, or if the device you're referencing is within a subckt model that isn't available from the schematic. Thirdly (didn't I say "two things"?), you need to check if there is hierarchy in the models below Mcp/Mbp - if that's a subckt, you may need to refer to the actual transistor inside to save the operating point. Regards, Andrew.![]()
↧