Hey! I used the fracture length of 5 squares to show the difference between extracted and non-extracted part. Initially, I was using infinite microns fracture length but then I wouldn't be able to show you the difference. Both give the same results though. The parasitic resistance should be around 600 Ohms but it is just 400 Ohms. To see why this was happening I reduced the fracture length and realized that, that space is not getting extracted in a way similar to other routing. Length is 240.843u and width is 1.26u. Parasitic resistance should be in order of 17 Ohms for that rectangle (the one not being extracted). Total should be around 20 Ohms but since only a part of it is extracted it shows 3 Ohms as parasitic resistance. Including all rectangles I should get 600 Ohms of parasitic R. If I query the big shape in layout view of the design, then in connectivity tab I don't see any net name. I didn't add any net name. Here is the screenshot for this. https://drive.google.com/file/d/1Lv35hjv9YxQvDTE-pChJA0SopYUt45ub/view?usp=sharing Thanks.![]()
↧