++ A few further comments, I wrote this post based on my efforts yesterday where it was running the plan, but not picking up the correct value. Today: I re-created my run plan (Run.0 and Run.1) and this time I cannot run it at all, as it has detected a dependency between the runs which it didn't complain about yesterday: "Message 9080: cannot simulate Run.1 because it depends on run " that does not exist correct the dependency and re simulate the run" I have also tried to put in place a workaround for the concurrency issue from Run.0 and Run.1, where I generate a specific value in an output at the end of Run.0 which I wanted to be used to trigger Run.1. But the options I saw yesterday for adding run conditions no longer pick up any tests or outputs for me to select and trigger on.![]()
↧