Hi Andrew, I delayed my reply until I did further investigations. First, The above error disappeared and I couldn't reproduce it. It disappeared after creating new maestro veiw! Regarding your reply, I did noise sim "ALL" not "USB", as I was simulating phase noise simultaneously for other nodes (LO signal of a receiver) together with the Rx output at baseband (relative harmonic=0) or absolute (while sweeping the target baseband frequency range). I expected that regardless of ALL or USB, for the baseband signal, should get the same result. The issue is that when plotting USB noise after doing USB-noise sim or ALL-noise sim, I get different results. This I cannot understand. Also when plotting the noise summary, different components are having different contribution for ALL and USB noise sims. So which one can I trust? Thanks for your support! Best regards, Ahmed.![]()
↧