I can't help you with Calibre (it's a Mentor tool) or Momentum or Golden Gate (they're Keysight tools), but if you know what the CDL needs to look like, it should just be a matter of defining in the Tools->CDF->Edit in the CIW, picking "Base" and then lib/cell for the component, and then in the Simulation Information tab, pick "auCdl" from the cyclic field, and fill in a netlist procedure (probably pick something like ansCdlCompPrim), and then the termOrder being the names of the pins of your component - you may need to be careful about the order, I don't know. The modelName should be whatever Calibre will use to recognise the device. For the most part, you probably would be best to ask Mentor about this, because the main challenge will be getting Calibre to recognise the device. Once that's sorted out, I'm sure they can help you get the netlisting sorted out so that it netlists whatever Calibre LVS is expecting. Regards, Andrew.![]()
↧