Hello cadence, In Assembler (ICADV12.30.ISR15). When using config view sweeps in a multi corner simulation, say in a 128 corner simulation as an extreme case, when do ALL the 128 netlists get created ? 1) All start of the simulation ? or 2) As the simulation progresses ? In other words when the simulation gets around to each corner. The reason why I ask is because, for a top-level block where many designers are poking around all the time and the simulation can span a few days, the netlist that will be created at the time of the simulation launch may not be the same as the one created a few days later. Obviously this would render the simulation results useless. If such is the case, are the settings or environment variables that can force the netlist creation of ALL 128 corners at the time of the simulation launch ? Regards, Frank![]()
↧