Iman, You still didn't answer my question about contacting customer support, you gave very imprecise version numbers (6.1.7.64-64b converts 21 different subversions) and you didn't say which INCISIVE version at all (so that's many, many versions). You also didn't explain how you included the DSPF - saying you included it from the Config could mean many things. The right way to do this is to keep the config picking the schematic view, and then use Setup->Simulation files and specify the DSPF there. That way you don't have to worry about getting the port order information defined so that the orders tie up. You do have to be careful that the port names in the DSPF match OK (I had to ensure they were [] rather than <> - there may be a way of getting this to work via the bus delimiter field underneath the DSPF file on the Setup->Simulation files form, but I'm reluctant to spend any more time guessing what you might have done, when the right thing to do here is for you to contact customer support as I suggested earlier, especially as you're not giving detailed enough responses here). Regards, Andrew.![]()
↧