Andrew, I did create my signal info file and had to fix the scope and upscope commands since I am trying to use the signals at the top level. The warnings are, yes, floating nets which are named the same as my signals in the .vcd file. I used an alias in the signal info file to give them the same name. The simulation has no error but it doesn't show the correct output. 1.) How do you plot the signals from the .vcd file using ADE-L or spectre? 2.) How do I know that the signal name in the .vcd file gets fed properly into the net in the analog schematic? Here is a snapshot of my .vcd file: $comment TOOL: simvision(64) 14.10-p001 $end $date Jan 24, 2018 17:56:11 $end $timescale 1ps $end $var wire 1 # cleara $end $var wire 1 $ clearb $end $var wire 1 % conna $end $var wire 1 & connb $end $enddefinitions $end #1066137000 $dumpvars 0# 0$ 0% 0& $end #1066803200 and my .signal file .hier 0 .alias cleara clear33a .alias clearb clear33b .alias conna conn33a .alias connb conn33b .out cleara clearb conna connb .trise 100 cleara clearb conna connb .tfall 100 cleara clearb conna connb .voh 1.8 .vol 0.0 Thanks again Andrew! Al![]()
↧